| 
USER’S GUIDE460 CyberSWITCHUnexpected error during transmission of LMI frameA system error occurred during the actual transmit request for an LMI frame. Contact yourDistributor or Customer Support.Unknown Calling Bridge MAC address security is enabled and the remote Combinet does not match any of the defineddevices.Unknown DLCI in CLLM messageThe network has sent a CLLM message which has referenced the indicated DLCI that has not beenconfigured. Check the system configuration for the indicated DLCI.Unknown Security AssociationAn incoming datagram specifies a Security Parameter Index (SPI) which has not been defined onthis node. Verify the encryption parameters on both nodes. Adjust if necessary so that both nodesreflect the same SPI.Unmatched Login TaskThis represents an internal system error. Contact your Distributor or Customer Support.Unsupported Combinet protocol received: An unsupported Combinet protocol attempted to connect to the system. Contact your Distributor.You may need to upgrade software to support this.Unsupported Combinet protocol version received: ‘‘. [Device: ]An unsupported Combinet version attempted to connect to the system. Contact your Distributor.You may need to upgrade software to support this.Updating CyberSWITCH from “”The specified file, received during a Reliable Remote Upgrade, was successfully loaded intomemory and will now be verified before installation into the Flash File System.User Level Authentication flag is enabled for Terminal User xxx. Setting flag to disabled.The device definition for xxx should have User Level Authentication disabled.These two messages are displayed together. In device entries for terminal server connections, user-level authentication should not be enabled. In the event the CyberSWITCH finds an enabledcondition, it will disable the pertinent flag for the duration of the call only. To avoid this situationpermanently, disable the user level authentication flag in device entries for all terminal serverconnections.Waiting for WAN card in slot to complete initializationDownload process update for WAN card in slot .WAN card in slot signals it is operationalDownload process update that indicates that WAN card in slot is now operational.WAN Port is now in the Forwarding stateWAN port connections used by the bridge are now entering the specified state.WAN Port is now in the stateThe WAN connection port used by the bridge is entering the specified new state. |
