Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

Small Office Remote Access Switch 337S YSTEM VERIFICATIONVerifying Bridge is InitializedIf the system displays this message, then the test packet was transmitted correctly.If this message IS NOT displayed, then the LAN connection failed. Refer to LAN Attachment inthe Problem Diagnosis chapter.V ERIFYING B RIDGE IS I NITIALIZEDTo verify that bridging has initialized properly:1. Determine if the bridge is in the forwarding state by viewing the system messages. At theadministration console type:dr 2. Thedr command displays the current system messages. Look for the following LAN adaptermessages among the system messages:LAN Port #> is now in the LISTENING stateLAN Port #> is now in the LEARNING stateLAN Port #> is now in the FORWARDING stateNote: Other messages may also be displayed with these LAN messages.If you see these bridge initialization messages, then bridging is operational. If these bridgeinitialization messages are NOT displayed, refer to Bridge Initialization in the Problem Diagnosischapter.V ERIFYING IP R OUTER IS I NITIALIZEDTo verify that IP routing has initialized properly:1. View the system messages. At the administration console type:dr 2. Look for the following IP message among the system messages:[IP] IP router is initialized successfully3. For each IP interface that has been configured, the following interface initialization messageshould be displayed among the system messages.[IP] Network initialized successfully on ddd.ddd.ddd.dddNote: Other messages may also be displayed with the IP router initialization messages.If you see these IP router initialization messages, then the IP router is operational. If these IProuter initialization messages are NOT displayed, refer to IP Routing Initialization in the ProblemDiagnosis chapter.