Small Office Remote Access Switch 431SYSTEM M ESSAGESSystem Message Summary[IPAP] ResMem returned invalid device maximum value (x)A memory allocation failure was encountered by the IP Address Pool Manager during initializationprocessing. Contact your Distributor or Customer Support.[IP] Cannot get system memory for xxxxThere is not enough system memory available for IP software to operate (“xxxx” is a variable nameinternally used). Contact your Distributor or Customer Support.[IP] Cannot process incoming remote IP device , no rsc availThe IP software was unable to accept the incoming IP device to a WAN (Direct Host) interfacebecause it could not obtain necessary resource. The WAN connection may remain for a while, butthe remote IP device will not be able to communicate with any IP devices over WAN. Contact yourDistributor or Customer Support.[IP] Cannot start Proxy Arp for , no cmd buf availThe IP software attempted to start the proxy arp for the IP device indicated by the ,but was unsuccessful because it could not obtain necessary memory. Contact your Distributor orCustomer Support.[IP] Cannot stop Proxy Arp for , no cmd buf availThe IP software attempted to stop the proxy arp for the IP device indicated by the ,but was unsuccessful because it could not obtain necessary memory. Contact your Distributor orCustomer Support.[IP] Datagram with destination address of cannot be forwarded[IP] Reason: Invalid Device Info. Device is not IP callableThese two message appear together if a user calls in to the specified destination user and that useris not configured to be IP callable.[IP] Default Route not added, invalid next hop ()Because of an incorrect setup, the default route entry was not added in the routing table. Check thenext hop in your configuration. Be sure that the next hop indicated by the is directlyconnected to the configured network interface.[IP] Failed to de-register with IP Address Pool Manager (erc=x)A failure was encountered by the IP subsystem during initialization processing. IP made anunsuccessful attempt to de-register as a provider of “static” addresses for the IP address pool.Contact your Distributor or Customer Support.[IP] Failed to register with IP Address Pool Manager (erc=x)A failure was encountered by the IP subsystem during initialization processing. IP made anunsuccessful attempt to register as a provider of “static” addresses for the IP address pool. Contactyour Distributor or Customer Support.[IP] Initialization failureThe IP Router was not initialized correctly because of other errors. Possible errors include “[IP]Cannot get system memory for xxxx”. Refer to the log for additional messages to pinpoint theproblem.[IP] Invalid configuration for Network Interface ddIP routing is not properly configured. Refer to the IP Network Interfaces section to verify.
