Small Office Remote Access Switch 421SYSTEM M ESSAGESSystem Message SummaryDM card in slot is not functionalThe system was unable to initialize the Digital Modem in the specified slot correctly. Check allswitch and/or jumper settings on the board to ensure they match the values in CFGEDIT. If theboard is configured properly, and this message still appears, contact your Distributor or CustomerSupport.DM card in slot will receive new firmwareInformational message stating that the system has detected that the current firmware of thespecified modem is a lower revision level than what is supported in the currently installedsoftware. For 56K modem technology, the system will attempt to update the card. For modemtechnology other than 56K, the upgrade command must be used to upgrade the firmware revision.Watch for subsequent log messages to ensure the update is successful.DM card in slot failed FLASH downloadThe system has failed to successfully update the firmware revision of the Digital Modem card.Contact your Distributor or Customer Support.DM card in slot FLASH download completeInformational message stating that the system has successfully updated the firmware present onthe Digital Modem card.DM card in slot signals it is operationalInformational message stating that the Digital Modem is now ready for use.DM card type configured in slot does not existUsing the resource database, the system has tried to initialize a Digital Modem card that doesn’texist. Check all switch and/or jumper settings on the board to ensure they match the values inCFGEDIT. If the board is configured properly, and the message still appears, contact yourDistributor or Customer Support.DM card in slot will not come out of resetThere are problems initializing the board. Contact your Distributor or Customer Support.DM upgrade timeout. Board=, Modem=DM upgrade error during download. Modem says = xxxDM upgrade no response at start. Board=, Modem=DM upgrade flash erase failed. Board=, Modem=DM upgrade no response at end. Board=, Modem=There were problems while attempting to update the firmware of the specified modem due toeither a corrupt firmware file or hardware problems. Reseat the card in its ISA slot, and/or checkthe MVIP cabling. If problems persist, contact your Distributor or Customer Support.DM upgrade started. Board=, Modem=The system has begun to update the firmware of the specified modem on the Digital Modem card.Watch for subsequent log messages to ensure the update is successful.DM session in unknown upgrade state. Board=, Modem=There were problems while attempting to update the firmware of the specified modem due toeither a corrupt firmware file or hardware problems. Contact your Distributor or CustomerSupport.
