Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

USER’S GUIDE426 CyberSWITCHFailed to obtain Terminal info in smgr_proc_terminal_auth_sess 0A session control block was not found for this authentication session. Contact your Distributor orCustomer Support.Failed to start a Terminal Auth session. Device + User level Security not enabledA terminal mode connection was received and Device + User level security was not enabled. Verifycorrect security settings and default async protocol settings.FAILED XMODEM INITIALIZATIONThe UART controlling the Console Information Port (CIP) could not be initialized. The system willautomatically reset and attempt a reboot in an effort to correct the problem. If the system continuesto fail, make note of the displayed messages, and contact your Distributor or Customer Support. Asoftware update is likely needed.FAILED XMODEM SESSIONThe X-Modem session did not successfully terminate. Likely causes include exhausting timeoutlimits and noisy lines. The system will automatically reset and attempt a reboot in an effort tocorrect the problem. If the system continues to fail, make note of the displayed messages, andcontact your Distributor or Customer Support. A software update is likely needed.Failure during read of file for WAN card in slot If seen repeatedly, the above message indicates a problem with your hard drive. Contact yourDistributor or Customer Support.Failure during read of file ’s’The WAN card initialization subsystem encountered an error reading the file indicated. Check forproper software installation.Failure during Static RAM test on adapter # ’x’The WAN card bootstrap program encountered an error during the Static RAM test. This indicatesthat the adapter card may be faulty. Contact your Distributor or Customer Support.Failure on closure of file Failure on file closure Failure on write of file Failure opening file If seen repeatedly, the above messages indicate a problem with your hard drive. Contact yourDistributor or Customer Support.Failure to allocate enough memory for XILINX load fileThe WAN card initialization subsystem failed to allocate a buffer for use in downloading files.Restart the system. Report the problem if it continues.File=l2, Fn=, err=Layer 2 Error, port=, CES=A Layer 2 error was encountered on the indicated BRI link or port. Your ISDN line (data link) maybe going down. If this error condition persists, contact your Distributor or Customer Support.Below are possible error messages and their corresponding definitions:DISC rcvdThe Network has sent a Layer 2 DISC (Disconnect), terminating the data link. An attemptwill be made to re-establish the data link after a switchtype-dependent delay.