| 
USER’S GUIDE412 CyberSWITCHBridge is operating in RESTRICTED modeBridge is operating in UNRESTRICTED modeOne of the above messages will be displayed to indicate the configured Bridge mode of operation.Calculating CRC’s.....An X-Modem transfer has been completed and the received data is being checked for integrity.Call control detected near end problem - Slot= Port=The system detected a problem when initiating a call over the indicated line. The call will be retriedover a different line if possible.Calling Line ID Failure, Duplicate ID - A call has come in for a device that is using Calling Line Id (CLID) as the only authenticationmethod, and the given CLID is not unique across all devices.Calling Line ID Security Failure The system has rejected a device due to a mismatch between the Calling Line Id presented by thecaller and the Calling Line Id in the on-node device database or obtained via an off-nodeauthentication server such as RADIUS.Calling Line ID Security Failure , Device: The system has rejected a device due to a mismatch between the Calling Line Id presented by thecaller and the Calling Line Id in the on-node device database or obtained via an off-nodeauthentication server such as RADIUS. The device’s name is also contained within the database.Calling Line ID Security Failure - off-node authentication server not supportedThe system authentication type is configured to obtain device information off-node, for examplefrom a RADIUS server; however, such transactions are not yet supported when Calling Line IdSecurity is enabled.Call_ID in use in HOST_CALL_REQUESTThe system software sent a message to the RBS state machine that the state machine was unable torecognize or the information was incorrect. If this message is displayed in the log messages, contactyour Distributor or Customer Support.Call Rejected, Maximum Bandwidth already in place to Device Id An incoming call was rejected because the Maximum Data Rate parameter was exceeded for theindicated device. The Maximum Data Rate parameter can be configured for PPP devices under theconfiguration utility CFGEDIT or through the Manage Mode.Call Rejected, No Called TN IEThe switch did not deliver an Information Element for the call. This problem normally occurs if youare connected to a point-to-point line and have the System configured for a multipoint line. If youare connected to a multipoint line and get this message, call your phone company and report theproblem.Call Restrictions have been disabled by user commandThe user has disabled Call Restrictions via thecallrest off Dynamic Management command.Call Restrictions have been enabled by user commandThe user has enabled Call Restrictions via thecallrest on Dynamic Management command. |
