| 
USER’S GUIDE446 CyberSWITCHPVC for DLCI > not ACTIVEA frame was received on the PVC associated with the indicated DLCI which was not active. This isa temporary condition, and results from an asynchronous operation between the network andcustomer-premise equipment regarding the state of the individual PVCs. If this problem persists,contact your Distributor or Customer Support.PVC not allocated for The frame relay software received a frame from the network on PVC using the indicated DLCIwhich has not yet been configured. It is likely that there is a configuration mismatch between nodesin the network such that a node is transmitting data to the node logging this error via a valid butas yet unallocated PVC.PVC rcv wait q already fullIndicates a lack of system resources to handle the level of traffic being experienced. Contact yourDistributor or Customer Support.RADIUS authentication is not available. You must first ENABLE RADIUS user level authentication.An attempt was made to configure the Terminal Server Security for RADIUS and RADIUS was notconfigured on the CyberSWITCH.RBS: Channel - Backing off of channel, GLARE detected.An incoming and outgoing call occurred on the indicated channel at roughly the same time. Thesystem discontinued the outgoing call in order to allow the incoming call to be established.RBS: Encountered unknown source ID.RBS_out_SM: NO Dial Digits supplied.RBS: Received unknown primitive from CC.RBS: Received unknown primitive from L1.RBS: Received unknown primitive from ME.RBS: Received unknown primitive from RBS.The above Robbed Bit Signaling messages indicate that the system software sent a message to theRBS state machine that the state machine was unable to recognize or the information was incorrect.If this message is displayed in the log messages, contact your Distributor or Customer Support.RBS: LIF_AddTimer failure.An event occurred that the RBS task interpreted as a call signaling event, but layer 1 is not properlyinitialized. Ensure that an ISDN line is not plugged into a RBS card.RBS: LIF_GetBuffer failure.RBS: Unable to send host CALL_CLEARED.RBS: Unable to send host CALL_CONNECTED.RBS: Unable to send host CALL_REQUEST_ACK.RBS: Unable to send host HOST_CALL_INDICATION.RBS: Unable to send host REMOTE_DISCONNECTRBS: Unable to send package to host.The above Robbed Bit Signaling messages indicate that the WAN card is not communicatingproperly with the host, probably due to a card failure. Contact your Distributor or CustomerSupport.RBS_out_SM: Timeout waiting for WINK.The system went off-hook and the switch never “winked” back, going off-hook for a specifiedamount of time and then returning to on-hook. The switch must wink back in order to tell the |
