| 
Small Office Remote Access Switch 443SYSTEM M ESSAGESSystem Message SummaryNot enough memory for Security moduleNot enough system memory available to operate security module. Contact your Distributor orCustomer Support.No UA seen in response to SABMEs - Slot= Port= Ces=Layer 2 cannot be established between the system and the switch. This could be a TEI configurationmismatch between the system and the switch for the indicated line. Check the configuration of thesystem. If this is not the problem, call your carrier. The configuration of the switch may needcorrection, or the line may need to be manually restarted.No VCB buffer availableRan out of sending buffers for messages to Combinet. If this is a recurring problem, contact yourDistributor or Customer Support.Number of optional connections reduced from xx to yy due to memory limitationsThis informational message identifies that there is not enough memory available to accommodatethe system’s total capacity load for optional connections.Number of required connections reduced from xx to yy due to memory limitationsThis informational message identifies that there is not enough memory available to accommodatethe system’s total capacity load for required connections.Offnode server lookup of Dial Out User failed.Off-node authentication was not successful. Most likely, the device attempting to authenticate wasnot configured. Check configuration.OSW , found in the Flash File System. The OSW has not been updated from this file dueto insufficient Flash File System space. Please delete unnecessary files from the system.Delete unneeded files to free up Flash File System space, and reboot the system. DO NOT DELETENEX.BIN, IOP.BIN, OR UPGRADE.BIN. The system will again attempt to install the compressedfile set after the system is rebooted again.Outgoing calls barred - Slot= Port=The system cannot place outgoing calls on the indicated line. The switch must be configured tohandle circuit switched data calls. Contact your phone company and report the problem.Out of CCBs, Port=, CallRef=Contact your Distributor or Customer Support.Out of LAN Adapter transmit command descriptorsThe LAN adapter is temporarily out of buffers used to transmit frames on to the Ethernet. Thiscondition should clear. If it persists, contact your Distributor or Customer Support.Out of overflow RAM buffersContact your Distributor or Customer Support. |
