| 
Small Office Remote Access Switch 509S YSTEM COMMANDSCall Control Commands name> could not be found in the Device TableIndicates that the device name could not be found in the table of configured device names. name> is already connectedIndicates that a connection to a device can not be initiated if there is already a connectionto that device. The call device command cannot be used to increase bandwidth for anexisting connection.Call attempt failedIndicates that the request could not be executed.More than one match for name> found in the Device TableDisplayed if you enter just part of a device name and that part could specify more than onedevice name. You will be prompted to enter the device name again, in a more specificmanner. For example, ifcall device Sch is entered, and there is a device configuredwith the name Schultz, and a device configured with the name Schmidt, this messagewould be displayed. You would then need to enter at leastcall device Schu tosuccessfully initiate a call to the device Schultz. name> is not callableEach PPP device in the device database can have one or two phone numbers at which theycan be called. This message is displayed if the device has no phone number specified.Re-enter the name, or to cancelThe device name must be re-entered.Unable to prompt for device name at this timeIndicates that thecall command would prompt you for a device name, but the necessaryresources are not available. The recommended actions are as follows:1. If possible, enter the device name on the command line.2. If the device name cannot be entered from the command line (for example, the devicename contains command line delimiters of a space, a comma, a colon, or a tab), the usercan wait for a few minutes and see if any resources become available.3. If actions 1 and 2 are ineffective, this may indicate an internal problem in the System,please inform your service representative of the occurrence.call peer number> [data rate] [device] [bearer]Initiates a call to a peer at the given number. Entering the data rate, device, and bearer isoptional. We describe each of the optional fields below.data rateThe default data rate value for HDLC calls is 56Kbps. The default data rate for digital modemcalls is Auto.deviceThe valid values are:• HDLC: used for normal HDLC-ISDN calls• DM: used for Digital Modem calls. |
