Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

USER’S GUIDE226 CyberSWITCHC ONFIGURING TCPIf you have selected TCP as your IP protocol, a screen similar to the following is displayed. Notethat the following TCP defaults constitute a wild card match for any TCP packet:1. Select TCP Source Port. Note that the ports are specified in terms of an operator.2. Select a comparison operator.3. If you have chosen the comparison operator of “RANGE”, you will be prompted for upper-rangeand lower-range values. If you have chosen a comparison operator other than “RANGE”, you will beprompted for a specific TCP port number.4. Select TCP Destination Port. Note that the ports are specified in terms of an operator.5. Select a comparison operator.6. If you have chosen the comparison operator of “RANGE”, you will be prompted for upper-rangeand lower-range values. If you have chosen a comparison operator other than “RANGE”, you will beprompted for a specific TCP port number.7. Select TCP Control.8. Specify a control value (any, established, or not established).C ONFIGURING UDPIf you have selected UDP as your IP protocol, a screen similar to the following is displayed. Notethat the following UDP defaults constitute a wild card match for any UDP packet:1. Select UDP Source Port. Note that the ports are specified in terms of an operator.2. Select a comparison operator.PACKET TYPE "Type_One":1) IP Source Address AND 0.0.0.0 EQUAL 0.0.0.02) IP Destination Address AND 0.0.0.0 EQUAL 0.0.0.03) IP Protocol EQUAL TCP4) TCP Source Port RANGE 0 - 655355) TCP Destination Port RANGE 0 - 655356) TCP Control ANYSelect function from above or for previous menu:PACKET TYPE "Type_One":1) IP Source Address AND 0.0.0.0 EQUAL 0.0.0.02) IP Destination Address AND 0.0.0.0 EQUAL 0.0.0.03) IP Protocol EQUAL UDP4) UDP Source Port RANGE 0 - 655355) UDP Destination Port RANGE 0 - 65535Id of the item to change, to accept changes or

to cancel