Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

USER’S GUIDE436 CyberSWITCH[IPX RIP] Shutdown complete.The IPX RIP protocol was successfully shutdown via Dynamic Management. No IPX RIP routinginformation will be transmitted or received. Any routes learned via IPX RIP will soon expire.[IPX RIP] Space available in routing tableA route entry has become available in the full route table.[IPX RIP] Unable to add route, routing table fullThe route table has become full. The maximum number of route entries should be increased. Note:This message will not recur in the log until space becomes available in the route table.[IPX SAP] Buffers allocatedThe IPX SAP successfully allocated the buffers needed to transmit IPX SAP packets.[IPX SAP] SAP Protocol Initialization successfulThe IPX SAP protocol was successfully initialized.[IPX SAP] Shutdown completeThe IPX SAP protocol was successfully shutdown via Dynamic Management. No IPX SAP serviceinformation will be transmitted or received. Any services learned via IPX SAP will soon expire.[IPX SAP] Space available in service tableA service entry has become available in the full service table.[IPX SAP] Unable to add service, service table fullThe service table has become full. The maximum number of service entries should be increased.Note: This message will not recur in the log until space becomes available in the service table.[IPXCP] Add Network Address to Pool with value above This message informs the administrator that negotiation was not possible since non-convergencewas detected the network address sent by the peer was not acceptable by us and we do not haveany network address to assign to the peer. The possible remedy is to configure more IPX addresseswith a value more than in the Address Pool.[IPXCP] IPX Address Match.[IPXCP] Device address same as another device addressThe remote device indicated by requested to use an already existing IPX network numberand node number.[IPXCP] Our Node Address is This message informs the administrator that the peer has assigned us a node number because thesystem did not have a node address and the peer needs a node address. This node address will beused by the peer to identify this system.[IPXWAN] Master Slave Conflict. Change Internal Network Number above This message indicates that over the IPXWAN link, the master and slave roles could not bedetermined. The internal network number of the system must be changed to ensure properIPXWAN negotiation to occur.[IPXWAN] IPX Internal Network Number must be configured.You must configure a valid internal network number in order for IPX routing to work properly.