Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

Small Office Remote Access Switch 205CONFIGURING ADVANCED BRIDGINGBridge Filters5. Configure protocol filters.a. Select to add a protocol filter.b. Select a protocol definition Id.c. Select a distribution list.6. Configure packet data filters.a. Select to add a packet data filter.b. Enter the off set value.c. Enter the mask in hex.d. Enter the data value in hex.e. Select a distribution list.7. Configure hardware filters.a. If you have configured the mode of hardware filtering as manual:• enter the MAC address you want to includeb. If you have configured the mode of hardware filtering as auto:• enter maximum number of filters to learn• enter address learning time-out• enable or disable Flush & ReLearn Time-Out• enter the time-out value for Flush & ReLearn Time-OutU SING M ANAGE M ODE COMMANDSManage Mode can be used to complete all of the bridge filter configuration. This section providesyou with the commands available for each bridge filter type.Protocol Definition CommandsprotdefDisplays the current protocol definition configuration data.protdef addAllows a protocol definition to be added to the current configuration. Refer to the UsingCFGEDIT section for required configuration elements (page 204). Configure any neededprotocol definitions (page 209).protdef changeAllows the current protocol definition configuration to be changed.protdef deleteAllows a protocol definition to be deleted from the current configuration.Source MAC Filter CommandssrcfiltDisplays the current source address filter configuration data.srcfilt addAllows a source address filter to be added to the current configuration. Refer to the UsingCFGEDIT section for required configuration elements (page 204).