USER’S GUIDE410 CyberSWITCH[AUTH] TACACS LOGIN rejected user: The remote Authentication server rejected the named user. This indicates that one of the followinghas occurred:1. The is not in the remote Authentication server’s database.2. The is entered incorrectly in the remote Authentication server’s database.[AUTH] TACACS No server configured for designated database location.TACACS is configured as a database location for security authentication. Either no TACACS serverhas been configured or an error occurred when parsing the TACACS server configuration.[AUTH] Warning code: 0001 TimeoutThe configured authentication server(s) did not respond to requests for user authentication. Eitherthe authentication server is not up and running, or it cannot access the IP address.[AUTH] Warning code: 0002 Missing required attribute from serverThe response message from the authentication server did not provide all required attributes foruser authentication. The attributes required vary, depending on type of service, and type ofsecurity. Refer to the RADIUS Authentication Server User’s Guide for details. Then check userentry for all required attributes.[AUTH] Warning code: 0003 No UDP buffer availableInternal resources were not available to send/receive an authentication message. Contact yourDistributor or Customer Support.[AUTH] Warning code: 0004 No authentication node availableInternal resources were not available to initiate an authentication session. Contact your Distributoror Customer Support.[AUTH] Warning code: 0005 No host configured for server IP addressThe System does not have a network route to the configured authentication server(s). Verify that astatic route has been set up. Then, check your configuration for the correct addresses on interfacesand authentication server.[AUTH] Warning code: 0006 UDP system failedInternal resources were not available to initiate an authentication session. Contact your Distributoror Customer Support.[AUTH] Warning code: 0007 Authentication mode mismatchAn internal request for authentication server access request occurred, but the System is configuredin the on-node device table mode. Contact your Distributor or Customer Support.[AUTH] Warning code: 0008 Authentication agent not initializedThe System could not obtain enough internal resources for the user authentication operation.Contact your Distributor or Customer Support.[AUTH] Warning code: 0009 Server failed message digest testA message received from the authentication server did not have the correct authenticator fieldvalue.
