Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

Small Office Remote Access Switch 437SYSTEM M ESSAGESSystem Message SummaryL3_CallRefSelect Call Reference wrappedStatus message indicating that Layer 3’s call reference value has wrapped. If this message is postedfrequently, report the problem.LAN Adapter AbortThe Ethernet adapter or subsystem is being interrupted as part of the error recovery process. If thesystem fails to operate normally, or the warning continues to occur, then report the event using theproblem reporting form included in Getting Assistance.LAN Adapter Command TimeoutThe system expected a command from the LAN adapter or subsystem that it did not receive. Checkfor proper LAN adapter configuration and hardware installation. If it persists, report the eventusing the problem reporting form included in Getting Assistance.LAN Adapter configuration conflictThere is a configuration conflict between the Ethernet resource that was installed and the Ethernetresource that was configured. Correct the configuration to match the installation.LAN Adapter Fatal Error ReportedLAN Adapter hardware failure detected. If the problem persists, replace your LAN adapter.LAN Adapter FIFO Data UnderrunThe system expected data from the adapter that it did not receive, and the system will continue tooperate. Check for proper LAN adapter configuration and hardware installation.LAN Adapter FIFO not empty, status=The LAN adapter did not enter the proper state after it was restarted. Check for proper LANadapter configuration and hardware installation.LAN Adapter HW upgrade may be requiredOlder versions of the Ethernet adapter may need to be updated to run Release 2.3 or greater. If theabove message appears in your system log messages, you will need to remove your Ethernetadapter to determine if it is a version that needs to be updated. Refer to the “Notes and Warnings”section of the Release Notes for further instructions.LAN Adapter HW upgrade requiredOlder versions of the Ethernet adapter may need to be updated to run Release 2.3 or greater. If theabove message appears in your system log messages, you will need to upgrade your Ethernetadapter.LAN Adapter LAN Controller errorThe system detected an error with the LAN controller. The LAN adapter card may be faulty.Contact your Distributor or Customer Support.LAN Adapter not configuredThe system tried to access the bridging function when it was not configured. Most likely, theEthernet resource was accidentally deleted. Correct the system configuration to reflect the properEthernet resource.LAN Adapter out of receive buffers for LAN port The LAN adapter is temporarily out of receive buffers for the indicated port. This condition shouldclear itself. If the condition persists, contact your Distributor or Customer Support.