| 
Small Office Remote Access Switch 423SYSTEM M ESSAGESSystem Message SummaryEDS-DES Board AbsentEDS-FEAL Board AbsentThe encryption board is either physically not in the backplane, or the dip switches on the board areset incorrectly. Check for the board; verify the switch settings.Error closing file ’s’The WAN card initialization subsystem encountered an error while downloading a WAN card. Thesystem could not close the download disk file indicated. Restart the system. If the error continues,Contact your Distributor or Customer Support.Error closing file , slot Error closing password data fileIf seen repeatedly, the above messages indicate a problem with your hard drive. Please contactyour Distributor or Customer Support.Error downloading bootstrap program to adapter # ’x’The WAN card initialization subsystem encountered an error on the indicated adapter whiledownloading the bootstrap program. Restart the system and review the configuration for theadapter. If the problem persists, the indicated adapter card may be faulty; contact your Distributoror Customer Support.Error downloading operational software to adapter ’x’The WAN card initialization subsystem encountered an error on the indicated adapter whiledownloading operational software. Restart the system and review the configuration for theadapter. If the problem persists, the indicated adapter card may be faulty and you should contactyour Distributor or Customer Support.Error during channel initialization Access An error has occurred during the initialization of the indicated Frame Relay Access, or port. Likelycause of this entry is that the system has run out of memory. Contact your Distributor or CustomerSupport.Error during port initialization Access >An error has occurred during the initialization of the indicated Frame Relay Access, or port. Likelycause of this entry is that the system has run out of memory. Contact your Distributor or CustomerSupport.Error during PVC initialization Access >An error has occurred during the initialization of the indicated. Likely cause of this entry is that thesystem has run out of memory. Contact your Distributor or Customer Support.Error initializing WAN card: The system could not initialize the specified WAN card during system initialization. Check theWAN card installation and configuration. If the error continues, report the problem.Error in last LMI message detected Error >An error was detected in the last LMI message forwarded by the network. The error is identifiedby the indicated error code.Error loading WAN board, data verify error: adapter ’x’The WAN card initialization subsystem encountered an error during download verification. Thespecified adapter card may be faulty. Contact your Distributor or Customer Support. |
