Small Office Remote Access Switch 511S YSTEM COMMANDSCall Detail Recording Commandsdisc device name>Disconnects all calls to the specified device. To obtain the device name, enter the Manage Modeand issue thedevice command. Note that the device name is case sensitive.In response to thedisc device command, one of the following responses will be displayed:Disconnecting Indicates that the disconnect process has been initiated for the indicated device.No active connection to name>Indicates that the device that you are attempting to disconnect has no active connection.Themc or thecs command can be used to view the active connections. name> could not be found in the Device TableIndicates that the device name could not be found in the table of configured device names.More than one match for found in the Device TableDisplayed if you enter just part of a device name and that part could specify more than onedevice name. You will be prompted to enter the device name again, in a more specificmanner. For example, ifcall device Sch is entered, and there is a device configuredwith the name Schultz, and a device configured with the name Schmidt, this messagewould be displayed. You would then need to enter at leastcall device Schu tosuccessfully initiate a call to the device Schultz.Re-enter the name, or to cancelThe device name must be re-entered.Unable to prompt for device name at this timeIndicates that thecall command would prompt you for a device name, but the necessaryresources are not available. The recommended actions are as follows:1. If possible, enter the device name on the command line.2. If the device name cannot be entered from the command line (for example, the devicename contains command line delimiters of a space, a comma, a colon, or a tab), thedevice can wait for a few minutes and see if any resources become available.3. If actions 1 and 2 are ineffective, this may indicate an internal problem in the System,please inform your service representative of the occurrence.C ALL D ETAIL R ECORDING COMMANDSThe following commands are used to monitor and verify the call detail recording (CDR) feature.cdr statsDisplay the CDR statistics. Refer to Call Detail Recording Statistics, for the available statistics andcorresponding definitions.cdr stats clearClears the CDR statistics; setting them all to zero.
