| 
USER’S GUIDE424 CyberSWITCHError mapping WAN adapter # ’x’ into Host memory mapThe configured memory location of the indicated WAN card conflicts with another WAN card ordevice. Review the configuration for the indicated adapter.Error opening file Error opening file , section = Error opening file , slot If seen repeatedly, contact your Distributor or Customer Support.Error parsing old WAN (Direct Host) interface: bad formatThe information contained in the WAN (Direct Host) interface is invalid. To correct, use CFGEDITto reconfigure the interface.Error initializing WAN card: The system could not initialize the specified WAN card during system initialization. Check theWAN card installation and configuration. If the error continues, report the problem.Error parsing old WAN (Direct Host) interface: LAN interface for specified port already in useThis error may display after upgrading software which contains secondary IP addressing and an“old” style WAN (Direct Host) interface. To correct, use CFGEDIT to delete any WAN (Direct Host)interfaces on the problematic LAN port, and reconfigure them.Error parsing old WAN (Direct Host) interface: no LAN interface for specified port This error may display after upgrading software which contains secondary IP addressing and an“old” style WAN (Direct Host) interface. To correct, use CFGEDIT to delete the problematic WAN(Direct Host) interface. Afterwards, configure a LAN interface and then read the WAN (DirectHost) interface.Error parsing WAN (Direct Host) interface: no LAN interface for specified name The LAN network interface associated with this WAN (Direct Host) interface is not present. UseCFGEDIT to delete the problematic WAN (Direct Host). Check configuration for the suspect LANinterface; it most likely will not be there. Add LAN interface, then reconfigure the WAN (DirectHost) interface.Error opening file \system\ethernt2.binThe LAN adapter executable file could not be opened. Check for proper software installation.Error programming adapter # ’x’ hardwareThe WAN card initialization subsystem encountered an error while attempting to program thehardware on the indicated adapter. Restart the system and review the configuration for theadapter. If the problem persists, the indicated adapter card may be faulty; contact your Distributoror Customer Support.Error reading file , section = If seen repeatedly, the above message indicates a problem with your file system. Contact yourDistributor or Customer Support.Error reading file \system\ethernet2.bin,section = The specified section of the LAN adapter executable file could not be read. Check for propersoftware installation. |
