Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

Small Office Remote Access Switch 405SYSTEM M ESSAGESWarning MessagesSPANNING T REE M ESSAGESThe Spanning Tree protocol is only supported by the Ethernet-2 interface card.Spanning Tree protocol messages are prefaced with [STP]. During normal operation, whenSpanning Tree protocol is enabled, the system may report informational messages such as:[STP] A new Root Bridge has been detected[STP] LAN Port #> is now a Designated PortW ARNING M ESSAGESSystem warning messages signal events that you should investigate. These messages may benormal during certain network conditions, or they may indicate a problem. The system shouldcontinue to operate after posting a warning message. If the system fails to operate normally, thenreport it using the problem report form included in Getting Assistance.E RROR M ESSAGESWhen the system detects errors, it reports error messages. If the faulty component cannot beidentified, and an error condition persists, then report the error by using the problem report formincluded in Getting Assistance.S YSTEM MESSAGE S UMMARYThe following pages list all the informational, warning and error messages alphabetically. The textdescribes the messages, and includes suggestions for problem resolution (if applicable). Note thatthe trace messages have been isolated for your convenience, and are summarized in the nextchapter. # 000: Couldn’t open the file C:\SYSTEM\PLATFORM.NEIThe open operation failed, no further detail is available. # 0000: Error reading C:\SYSTEM\PLATFORM.NEIThe read operation failed, perform a software upgrade to reinstall the file. # 0000: Error reading platform type: there is no “plat name” fieldThere is no value following the “=” character in the “current setting” string. # 0000: Error reading platform type: there was no “=” in the stringThe “current setting” string has the format “=”. This error messageindicates that no “=” character exists in the string. # 0000: Error reading platform type: type value is too largeThe value in the “current setting” string is too large to represent an actual platformtype. # 0000: Error reading platform type: type was not converted to an intThe value in the “current setting” string could not be converted to an actualplatform type.