Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

USER’S GUIDE140 CyberSWITCHIf you select PVC, the list of available PVCs are displayed. The LCN of the selected PVC andthe X.25 Access Name are stored in the Device Table to bind the device to a particular virtualcircuit configuration:If you select SVC, you must enter the X.121 address of the remote DTE. You need the remoteDTE address to make the X.25 call to the proper remote device.8. Enter the authentication information needed. To begin entering the information, selectAuthentication from the Device Table Menu. The following menu will then be displayed:Provide the necessary device authentication information for your selected Line Protocol. (Referto On-node Device Database Security Requirements for details). For example, for a PPP device,specify a CHAP secret. Or, for an HDLC device, enter a Bridge Ethernet Address.Select the type of the Virtual Circuit1) Permanent Virtual Circuit (PVC)2) Switched Virtual Circuit (SVC) [default 2]: 1Current Permanent Virtual Circuits defined for X.25 Access #1, ’VMAX25’:id Type LCN Protocol-- ---- ---- --------1 PVC 1 RFC8772 PVC 2 RFC877Id of Virtual Circuit to associate with device "vma",or to cancel? 1Select the type of the Virtual Circuit1) Permanent Virtual Circuit (PVC)2) Switched Virtual Circuit (SVC) [default 2]: 2Enter the X.121 Address of the Remote DTEor press to cancel? 9987654321Device Authentication Menu: (device = "DAN")PPP:1) PAP Password ""2) CHAP Secret ""3) Outbound Authentication ENABLED4) User Level Authentication DISABLEDIP Host (RFC 1294):5) IP Host Id ""HDLC Bridge:6) Bridge Ethernet Address ""7) Bridge Password ""ISDN:8) Calling Line Id(s) ""Select function from above or for previous menu: