Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

USER’S GUIDE354 CyberSWITCHVERIFYING IPX R OUTING OVER A WAN CONNECTIONTo verify the operation of IPX Routing over a WAN connection:1. Determine if NetWare Client A can see the remote NetWare Server “remote.” To do this,activate NetWare Client A’s desktop network neighborhood feature. Then check to see if“remote” is included in Client A’s network neighborhood.2. If “remote” is included in Client A’s network neighborhood, them IPX over the WANconnection is operational. If it does not appear in the network neighborhood, then IPX over theWAN connection is not operational. Refer to IPX Routing Over the WAN Connection in theProblem Diagnosis chapter.VERIFYING T RIGGERED RIP/SAPVerify whether or not triggered RIP/SAP has started and is operational:1. Determine if triggered RIP/SAP has started by viewing the system messages. To display themessages, enter the following console command:dr 2. Look for following message among the system messages:Starting Triggered RIP/SAP for Peer>3. If this message is displayed, continue check to see if Triggered RIP/SAP is operational. Ifmessage is not displayed, refer to Triggered RIP/SAP Start Up.4. Determine if triggered RIP is operational. On the administration console, type:ipx trigrip stats5. Examine statistics for activity. Refer to Triggered RIP Statistics for possible statistics and theirdescriptions.6. Create a change in the route (for example, shut down a server). Again examine statistics (ipxtrigrip stats) to verify the change is propagated to other side.7. If statistics do not reflect change, refer to Triggered RIP/SAP Operation.8. Repeat process (beginning at step 4) for SAP, but substitute the following console command:ipx trigsap statsV ERIFYING THE APPLE T ALK R OUTING F EATUREVERIFYING APPLE TALK ROUTING IS I NITIALIZED1. Determine if AppleTalk routing has been initialized on the CyberSWITCH by viewing thesystem messages. To view the system messages, enter the following console command:dr