| 
Small Office Remote Access Switch 429SYSTEM M ESSAGESSystem Message SummaryFrame Relay PVC connection down: Slot=, Port=The Frame Relay PVC connection is down for the indicated slot and port number.Frame Relay PVC connection up: Slot=, Port=, DLCI=The Frame Relay PVC connection is up for the indicated slot, port, and DLCI index.FrBufFree: error during freeThe indicated error occurred during an attempt to free a buffer to its memory pool. Contact yourDistributor or Customer Support.FrUtl: No registered device for DLCI A frame was received on the PVC associated with the indicated DLCI, and no Frame Relay ServiceDevice had (as yet) registered to use this PVC.IePvcStatus: Received Status Report for unknown PVC # The indicated unknown DLCI was indicated in a STATUS message received from the network. ThisDLCI number is entered in the “unknown DLCI” list and can be displayed via the FR LMI systemconsole command.Incoming call from , Slot=, Port=, Chan= Rejected by BWReservationA bandwidth reservation message. Indicates that a call has come in from the indicated device, on aline that is not in this device’s profile. The call will be disconnected. If you see this message often,check the remote device’s configuration to prevent wasted calls.Initial TDM Clock Master: The external line indicated has been selected as the master clock source.Initializing...Displays the current state of the system (initialization).Installing File Set into Flash MemoryThe file set, received via X-Modem, has successfully passed its verification tests and is now beingwritten into the Flash File System.Insufficient space for buffer pool creationThere is not enough system memory to proceed with the creation of the requested size buffer pool.Contact your Distributor or Customer Support.Interrupt fault on WAN Adapter in Slot The interrupt jumper for the WAN Adapter in the specified slot is missing or misplaced.Invalid caller number: - The incoming call security feature is enabled and a call was received from an unknown remote site,therefore the call was disconnected. If the call was from a valid remote site, the device list must beupdated to include the remote site's phone number.Invalid Call_ID in HOST_CALL_CONNECTEDInvalid Call_ID in HOST_CALL_DISCONNECTThe above Robbed Bit Signaling messages indicate that the system software sent a message to theRBS state machine that the state machine was unable to recognize or the information was incorrect.If this message is displayed in the log messages, contact your Distributor or Customer Support. |
