Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

Small Office Remote Access Switch 277CONFIGURING IPXIPX-Specific Information for DevicesR EMOTE LAN D EVICESRemote LAN devices are configured in a slightly different way than WAN devices. Since theremote device is a bridge and not an IPX router, the IPX options for Remote LAN devices areconfigured under the bridge-level options, as follows:U SING CFGEDIT1. Select Security from the main menu.2. Select Device Level Databases from the security menu.3. Select On-node Device Entries from the device level databases menu.4. Press 1 to add a device.5. Enter the device’s name and press . You should provide ISDN and Authenticationinformation first.6. Select Bridging from the Device Table Menu. A menu similar to the following will be displayed:7. Enable Bridging and disable Make calls for bridge data.8. Select IPX Remote LAN Network Number. Provide the external network number for the RemoteLAN interface if desired. The default value, NONE, means the remote IPX external number willbe the default IPX Remote LAN interface network number. Refer to page 259.Note: The IPX Spoofing Options selection for Remote LAN devices is for a future release. Do nottry to configure at this time.U SING M ANAGE M ODE C OMMANDSdevice addAllows you to add a device entry to the Device List. You will be prompted for deviceinformation, including IPX information.device changeAllows you to change information for a specific device entry. This will allow you, for example,to add IPX information to a previously configured device entry.Device Bridging: (Device = "remote2")1) IP (Sub)Network Number NONE2) Bridging ENABLED3) Make calls for bridge data DISABLED4) IPX Remote LAN Network Number NONE5) IPX Spoofing Options6) AppleTalk Network Number NONESelect function from above or for previous menu?