| 
Small Office Remote Access Switch 501S YSTEM COMMANDSSetting the Date and TimeS ETTING THE D ATE AND T IMEThe following commands are used to set the date and the time on the system:date day, year>Changes the date on the system as specified. The can be specified as a numeral from1 to 12, spelled out in full (January), or abbreviated to 3 letters (JAN). The can be anylegal date within the month specified. (For example, 1 through 31 would be legal dates forJanuary.) The year may be specified in its entirety (1995) or by its last two digits (95). Commas,dashes, and white space are all acceptable separators.time hours:minutes <:seconds> Changes the time on the system as specified. The hours can be from 0 - 23 in military time, orfrom 1 - 12 in civilian time, with an optional AM/PM indicator. The “seconds” parameter isalso optional. If “P” is included (indicating “PM”), 12 is added to the hour. White space isunimportant.Note that if the time command is issued without any parameters, the system will report thecurrent time. Parameters following the time command are interpreted as an attempt to make achange.F ILE UTILITY C OMMANDSThe file utility commands include the flash commands and the simple file utilities.The flash commands give you the ability to update, format and reclaim unused space in theembedded system’s resident flash array. It provides the means to install and upgrade newsoftware.flash updateUsed only when you need to update the system software. It prepares for a software update byrebooting the system. When you receive the message “Waiting for Download,” transfer thenew software files to the system via your communications package.flash recoverSpecific to the remote upgrade of the Second Stage Boot or when recommended by the ReleaseNotes. The SSB update should be performed only upon recommendation of Customer Supportpersonnel. In the event that it is necessary to upgrade the SSB, this command starts the remoteupgrade, and bases its update on the \system\recover1 file. For the specific steps toperform a remote SSB upgrade, refer to Upgrading System Software.flash reclaimSearches the flash file system for files marked as deleted. The space occupied by the deletedfiles is then reclaimed and made available for other files.Because DOS is not supported on the CyberSWITCH, the following simple file utilities providebasic information:dirTakes no parameters, and displays all files currently in the flash file system, along with freespace in each partition. |
