| 
USER’S GUIDE430 CyberSWITCHInvalid CLLM received on Access An invalid CLLM message was received on the indicated Frame Relay Access. The message hadeither missing elements or invalid contents.Invalid LAN Adapter identifierThe system has detected invalid LAN adapter hardware. Check for proper LAN adapterconfiguration and hardware installation.Invalid Password givenThe remote Combinet sent a password that did not match any device table entries. This most likelyis due to a configuration error. Check the configuration, and change the password.Invalid SERIAL.001 file present, file is ignored.Contact your Distributor or Customer Support.Invalid SERIAL.BIN file present, system booting in minimal mode.Contact your Distributor or Customer Support.Invalid serial number in SERIAL.001, file is ignored.Contact your Distributor or Customer Support.Invalid serial number in SERIAL.BIN file, system booting in minimal mode.Contact your Distributor or Customer Support.IP Error from ESP datagram - discardedAn error occurred within the IP forwarding logic which make it impossible to send this datagram.[IP] Invalid Device Info. Device is not IP callable An IP packet could not be forwarded to a remote network because the next-hop device for thatnetwork is not configured as IP Callable. The CyberSWITCH returns a network unreachable messageto the sender.[IP] x.x.x.x not added to the pool: Invalid IP addressA failure was encountered by the IP subsystem during initialization processing. IP made anunsuccessful attempt to add a “static” address to the IP Address Pool. The IP address being addeddid not match any of the configured IP network interfaces.[IP] x.x.x.x not added to the pool: Invalid Device IdA failure was encountered by the IP subsystem during initialization processing. IP made anunsuccessful attempt to add a “static” address to the IP Address Pool. The ID supplied by the IPsubsystem was invalid. Contact your Distributor or Customer Support.[IP] x.x.x.x not added to the pool: IP Address Pool FullA failure was encountered by the IP subsystem during initialization processing. IP made anunsuccessful attempt to add a “static” address to the IP Address Pool. The IP Address Pool wasalready full.[IP] x.x.x.x not added to the pool: Unknown error (y)A failure was encountered by the IP subsystem during initialization processing. IP made anunsuccessful attempt to add a “static” address to the IP Address Pool. An unknown error code wasreturned by the IP Address Pool Manager. Contact your Distributor or Customer Support. |
