| 
Small Office Remote Access Switch 453SYSTEM M ESSAGESSystem Message Summary[STP] A BLAN Topology Change has been detectedThe system has detected a topology change in the Spanning Tree environment.[STP] A new Root Bridge has been detectedThe system has detected a new root bridge for the Spanning Tree environment.[STP] LAN Port is now a Designated PortThe indicated LAN port has become the designated port for the attached LAN.[STP] LAN Port is now the Root PortThe indicated LAN port has become the root port for the system.[STP] This Bridge is now the Root BridgeThe system has become the root bridge for the Spanning Tree environment.Successfully Loaded Release Issue The specified release of System software was successfully loaded into memory.Switch could not recognize phone number nnnnnnnThe switch did not accept the phone number dialed as a complete number. Check the correctnessof the phone number (including any leading digits such as 8 or 9).System Clock Fault on Wan Adapter in Slot Indicates a TDM bus connection failure. Check to make sure that the TDM bus has been correctlyconnected.TACACS authentication is not available. You must first ENABLE TACACS user level authentication.An attempt was made to configure the Terminal Server Security for TACACS and TACACS wasnot configured on the CyberSWITCH.TCP Connection to VRA Manager LostThe TCP connection to the SFVRA Connection Manager has gone down.TDM Clock Master changed TO (slot # , port# ) FROM (slot # , port # )The Clock Manager has dynamically adjusted the master clock source in response to an externalline state change.Temporarily unable to read flash file system due to flash reclaim in progress - try again laterThe system is automatically performing a flash reclaim to reclaim space previously occupied bydeleted files. Wait several seconds (up to a minute maximum) and try your file system commandagain.Terminal Server Security connections disabled. Dropping call.The Terminal Server Security is set to none and a terminal connection was requested. Checkconfiguration. Most likely, the Default Async Protocol is set to terminal with no Terminal ServerSecurity configured.Terminal Server Security is currently using this database. You must change the Terminal Server Securitysetting first.An attempt was made to disable a User Level Security Database when the terminal server wasconfigured to use this database for terminal mode authentication. |
