Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

USER’S GUIDE152 CyberSWITCHO N - NODE DEVICE D ATABASE S ECURITY R EQUIREMENTSThe following sections provide the On-node Device Table configuration requirements for possiblesecurity option configurations for each category of remote device. Categories are defined by theoperating mode (bridging or routing), and the line protocol in use.Bridging with HDLC Bridge DevicesTo allow a Bridge device to connect to the CyberSWITCH, you must have MAC Layer Bridgingenabled. For each HDLC bridge device using this type of connection, you may need to enter theDevice Name, Calling Line Id, Remote Bridge Ethernet Address, and Password.The following table identifies the configuration requirements for possible security options forremote bridge devices.*Conditionally Required means you must specify at least one of either the Calling Line Id or theEthernet Address. You may specify both.IP Routing with HDLC Bridge DevicesTo allow devices to connect to the CyberSWITCH using IP routing through a Bridge device, youmust configure a RLAN Interface. IP routing must also be enabled. For each HDLC Bridge usingthis type of connection, you may need to enter the Device Name, Calling Line Id, Remote BridgeEthernet Address, Bridge Password, and IP (Sub) Network Number.Security Mode Configuration On-node Device Table Configuration DataCalling Line Id Bridge EthernetAddressCalling Line Id Bridge EthernetAddressBridge PasswordEnabled Disabled Required NotRequestedNot RequestedDisabled Enabled Not Requested Required Optional perdevice entryEnabled Enabled ConditionallyRequired*ConditionallyRequired*Optional perdevice entry(if entry specifiesan EthernetAddress)