Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

Small Office Remote Access Switch 435SYSTEM M ESSAGESSystem Message Summary[IP RIP] Unable to open RIP/UDP port 520The UDP port for RIP was unable to be opened. There are 63 possible UDP ports, and none areavailable for use at this time. No RIP information can be transmitted or received. Contact yourDistributor or Customer Support.[IP RIP] Unable to register WAN Connection notificationThe IP RIP protocol was unable to register with the IP WAN interface connection notificationsystem. No WAN connection information will be reflected in the RIP packets. Contact yourDistributor or Customer Support.[IP RIP] Unable to register with Network Interface MaintenanceThe IP RIP protocol was unable to register with the IP network interface notification system. Anydynamic changes of the network interface configuration will not be reflected in the RIP interfacecontrol. Contact your Distributor or Customer Support.[IPX] Invalid IPXWC passedIn the unlikely event this message is posted, contact your Distributor or Customer Support.[IPX] Network initialized successfully on xxxxxxxx:xxxxxxxxxxxxThis message is posted when the numbered interface is successfully initialized on the indicated IPXaddress.[IPX] Network Interface on LAN port not initializedThe network interface for the LAN port indicated was not initialized because there is no Ethernetresource configured, or the Ethernet resource that is configured does not have the correspondingport. You should correct the system configuration.[IPX] Route not added: invalid next hop(The static route entry indicated by the was not added in the IPX routingtable because the next hop indicated by the is not located on any network directlyconnected to the configured network interface.[IPX] Route () not added: invalid next hop ()The static route entry indicated by the was not added in the IPX routingtable because the next hop remote device indicated by the does not exist.[IPX] IPX router initialized successfullyThis message is posted when the IPX Router feature has initialized successfully.IPX spoofing unable to get disconnect time structure. Default options replacing disconnect time options fordevice .The resources required to properly perform the configured IPX spoofing options for the specifieddevice after a connection to this device has been disconnected could not be obtained. The defaultIPX spoofing options are being used in place of the disconnect time IPX spoofing options.[IPX RIP] Buffers allocatedThe IPX RIP successfully allocated the buffers needed to transmit IPX RIP packets.[IPX RIP] RIP Protocol Initialization successfulThe IPX RIP protocol was successfully initialized.