Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

Small Office Remote Access Switch 141CONFIGURING D EVICE L EVEL DATABASESOn-node Device EntriesFor PPP, the ability to enable/disable outbound authentication (selection 3) is available.However, it is generally not necessary to enable outbound authentications on a point-to-pointline. If the device is associated with a frame relay virtual circuit, and the PVC name is differentthan the device name, then outbound authentication is required.In addition, if you want to add user-level security to IP, AppleTalk and bridge devices, youmay also enable User Level Authentication. This requires the user that initiates a connectionbetween the remote device and the CyberSWITCH to be authenticated at the user level as well.Refer to Device and User Level Security for details.Note: Do not enable User Level Authentication for terminal server devices which connectthrough the digital modem.Note: The CSX1200, CSX1000, and CSX150 no longer connect to devices which use the RFC1294 protocol to define their datalink headers. For these particular products only,disregard (i.e., do not select) the IP Host (RFC 1294) menu option on the DeviceAuthentication Menu.9. To enter any needed IP information for your device, select IP from the Device Table Menu. Thefollowing screen will be displayed:If your device requires an IP address, enter it now. Options are:• none for Direct Host or WAN links that plan to use dynamic address allocation• 0.0.0.0 for unnumbered WAN links• IP address # for traditional numbered WAN linksEnable or disable IP routing for this device.If you want dial-out capabilities to this device, enable Make calls for IP data.If you want to apply a predefined forwarding filter to this device, specify the filter name here.Refer to Forwarding Filters for more information.10. To enter any needed IPX information for your device, select IPX from the Device Table Menu.The following screen will be displayed:Device IP Menu: (device = "DAN")1) IP Address NONE2) IP Routing ENABLED3) Make calls for IP data ENABLED4) IP Input Filter NONE5) IP Output Filter NONESelect function from above or for previous menu:Device IPX Menu: (device = "DAN")1) IPX Routing DISABLED2) Make calls for IPX data DISABLED3) IPXWAN Protocol DISABLED4) IPX Routing Protocol NONE5) Spoofing OptionsSelect function from above or for previous menu: