| 
USER’S GUIDE448 CyberSWITCHResmem_gettotal: Enabled size , greater than Checksize for Internal error that should be reported to Customer Support.ResMem_Malloc failure for subsystem (size=, type=, class=, ra=)ResMem_Malloc Size too large for subsystem (type=, class=ra=)ResMem_Malloc Device not registered (ra=)ResMem_Obtainable Device not registered (ra=)Any of the above three messages indicate that an internal error has occurred that should bereported to Customer Support. The system will restart when this error occurs.Retrying download of DM card in slot in secondsThe system has failed on previous attempts to initialize the Digital Modem card. The system willretry a specific number of times before logging a failure message. Check the hardware and softwareconfiguration, reseat the card in its ISA slot, and/or check the MVIP cabling. If the problem persists,contact your Distributor or Customer Support.Rx Channel Inactivity DetectedNo keep-alive frames have been received over an active connection to a remote system. Thisindicates that the connection or the remote node has failed (or been powered-off) without anindication of the failure from the network. If the event continues, contact your Distributor orCustomer Support.Security Rejection - Bridge Address Security cannot use Authentication ServerBoth options (Bridge Address Security and off-node User Authentication) are not supportedsimultaneously.Security Rejection - Caller did not negotiate securityBridge Security is configured. A caller attempted to send device data before (or without)negotiating the Bridge Address security.Security Rejection - HDLC not supported by the callerA properly formed Bridge Security negotiation packet was received but the remote bridgeindicated that it did not support the HDLC protocol.Security Rejection - Invalid Calling Line Id - The calling line identifier has not been configured for any valid device in the system Device list. Thenumber indicates the actual number presented by the network.Security Rejection - Invalid Password () givenA properly formed Bridge Security negotiation packet was received. The bridge is registered in theSystem Device table and a password was provided, but the password provided did not match thepassword in the System Device table.Security Rejection - No Bridge Address given by callerA normal Bridge Security negotiation packet was received, but did not contain a bridge address.Check configuration. If problem persists, contact your Distributor or Customer Support. |
