Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

Small Office Remote Access Switch 153CONFIGURING D EVICE L EVEL DATABASESOn-node Device EntriesThe following table identifies the configuration requirements for possible security options for IPRouting with Bridge Devices.*Conditionally Required means you must specify at least one of either the Calling Line Id or theEthernet Address. You may specify both.IP Routing with IP Host Devices (RFC1294)To allow an IP Host device to connect to the CyberSWITCH, you must have IP Routing and IP HostSecurity enabled. For each IP Host device using this type of connection, you may need to enter thedevice’s IP address, IP Host Id, and Calling Line Id.The following table identifies the configuration requirements for possible security options for IPHost devices.IP Routing with PPP IP Devices (Using IPCP)To allow a PPP IP device to connect to the CyberSWITCH, you must have IP routing enabled. Foreach PPP IP Device using this type of connection, you may need to enter the device’s IP address, aPAP Password or a CHAP Secret, and Calling Line Id.Security ModeConfigurationOn-node Device Table Configuration DataCallingLine IdBridgeEthernetAddressCalling Line Id BridgeEthernetAddressBridge Password IP (Sub) NetworkNumberEnabled Disabled Required NotRequestedNot Requested Required if only IPRouting is EnabledDisabled Enabled NotRequestedRequired Optional perdevice entryRequired if only IPRouting is EnabledEnabled Enabled ConditionallyRequired*ConditionallyRequired*Optional perdevice entry(if entryspecifies anEthernetAddress)Required if only IPRouting is EnabledSecurity Mode Configuration On-node Device Table Configuration DataCalling Line Id IP Host Id Calling Line Id IP Host Id IP AddressDisabled Enabled Not Requested Required RequiredEnabled Enabled Optional perdevice entryRequired Required