Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

Small Office Remote Access Switch 275CONFIGURING IPXIPX-Specific Information for Devices4. Press 1 to add a device.5. Enter the device’s name and press . You should provide ISDN and Authenticationinformation first.6. Select IPX. A screen similar to the following will be displayed:7. Enable IPX routing. Select IPX Routing and follow on-screen instructions.8. Enable make calls feature. Select Make calls for IPX data and follow on-screen instructions onlyif the CyberSWITCH is to dial-out to remote1.9. Although IPXWAN Protocol appears on the menu, the feature is not yet completely functional.10. Select Routing Protocol. A menu similar to the following will be displayed:11. Select routing protocol. When you select Triggered RIP/SAP, you will need to identify the WANpeer type as either active or passive. An active peer receives broadcasts at all times; a passivepeer receives broadcasts only when a connection is up.12. Select Spoofing Options. Make changes to default spoofing setup, if desired, through thefollowing menu:a. Press 1 to configure IPX watchdog spoofing. The following menu will be displayed:Device IPX Configuration Menu: (Device = "remote1")1) IPX Routing DISABLED2) Make calls for IPX data DISABLED3) IPXWAN Protocol DISABLED4) Routing Protocol NONE5) Spoofing OptionsSelect function from above or for previous menu:IPX Device Routing Protocol Menu:1) None2) RIP/SAP3) Triggered RIP/SAPEnter selection or press for previous menu [default=None}:31) ACTIVE2) PASSIVETriggered RIP/SAP WAN Peer type [default=ACTIVE]:1IPX Device Spoofing Menu:1) IPX Watchdog Spoofing2) SPX Watchdog Spoofing3) Serialization Packet Handling4) Message Packet HandlingSelect function from above or for previous menu: 1