Small Office Remote Access Switch 507S YSTEM COMMANDSBridge Commandsatalk zoneThis command will display AppleTalk zone information. A sample output screen is shownbelow:The fields in this display are defined as follows:zoneThe AppleTalk zone name for the network that the AppleTalk port is connected to.network rangeSpecifies the network range associated with the indicated zone.B RIDGE COMMANDSThe following commands are used to display bridging information and statistics.pkt macEnables the MAC address monitor display. The MAC Address Monitor screen displaysinformation contained in the LAN frames that are sent over the ISDN connections. The packetsrepresented by the displayed MAC address pairs will not be captured unless the br pkt capturefeature is on (enabled).When the MAC Address monitor is enabled, the CyberSWITCH inspects each LAN frame sentor received over the ISDN connections. It displays the Destination MAC Address, Source MACAddress, and Ethernet type field for each LAN frame.In the above example, the DEST field is the destination MAC address field of the LAN frame.The SOURCE field is the source MAC address of the LAN frame. Next to the source MACaddress field is the location of that source address. An “L” next to the source address indicatesthat this address is “Local” to the CyberSWITCH. That is, it is attached to the Ethernet segmentlocally connected to the CyberSWITCH. An “R” next to the source address indicates that thisaddress is “Remote” to the CyberSWITCH. That is, it is attached to an Ethernet segment that isconnected to a remote ISDN device.zone network range------------------ -------------zone1 225 - 226zone2 236 - 237MAC Address MonitorDEST SOURCE TYPE COUNT DEST SOURCE TYPE COUNT90409A000000 00409A001023-L 3C09 00010 00409A001023 00409A001324-R 3C09 0014000409A001324 00409A001023-L 3C02 00141 90409A000000 00409A001000-L 3C09 0001090409A000000 00409A002345-L 8137 00015 00409A002345 00409A003217-R 8137 0004500409A003217 00409A002345-L 8137 00045Number of Packets Received 00406