Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

Small Office Remote Access Switch 343S YSTEM VERIFICATIONVerifying IP Routing Over InterfacesTo verify IP Routing over a LAN connection:1. Determine if the CyberSWITCH can access the local IP host. On the administration consoletype:ip ping 100.0.0.2 Issuing this command will result in a response similar to the following:100.000.000.002 is aliveIf the system displays this message, then IP routing over that LAN port is operational. Repeatthis step for each LAN port on your Ethernet resource.If this message IS NOT displayed, then IP routing over the LAN connection is not operational.Refer to IP Routing Over the LAN Connection in the Problem Diagnosis chapter.2. Once IP routing is operational on each LAN port on your Ethernet resource, then IP routingover the LAN Connection is operational.VERIFYING IP ROUTING OVER A WAN I NTERFACETo verify that IP routing is properly operational over a WAN interface, a remote IP Host must beoperational and available to initiate connections. Also, a local IP host must be connected to the localLAN port of the CyberSWITCH.Below is an example of a configuration used to verify IP routing over a WAN interface. It uses IPaddresses specific to the example. Substitute the IP addresses of your network when you performthe verification steps. It also uses the “ping” command. The “ping” command sends a packet to aspecified host, waits for a response, and reports success or failure. Substitute the equivalentcommand on your IP host.Host A100.0.0.1100.0.0.0100.0.0.2CSX150