USER’S GUIDE154 CyberSWITCHThe following table identifies the configuration requirements for possible security options for PPPIP Devices.*Required: An IP address is required if the remote device does not support IP address negotiation.When the remote device does support IP address negotiation, an IP address is not required.Note: If CHAP Security is enabled, and Outbound Authentication has not been disabled, a CHAPSecret must be entered for both the remote device and for the CyberSWITCH. Refer toSystem Information for information regarding the System Secret. If OutboundAuthentication has been disabled, a CHAP Secret is not required for the remote device.Bridging with PPP Bridge Devices (Using BCP)To allow a PPP Bridge device to connect to the CyberSWITCH, you must have Bridging enabled.For each PPP Bridge device using this type of connection, you may need to enter a PAP Passwordor a CHAP Secret, and a Calling Line Id.The following table identifies the configuration requirements for possible security options for PPPBridge Devices.Note: If CHAP Security is enabled, and Outbound Authentication has not been disabled, a CHAPSecret must be entered for both the remote device and for the CyberSWITCH. Refer to theSystem Information for information regarding the System Secret. If OutboundAuthentication has been disabled, a CHAP Secret is not required for the remote device.Security Mode Configuration On-node Device Table Configuration DataCalling Line Id PAP or CHAPSecurityCalling Line Id PAP PasswordorCHAP SecretIP AddressDisabled Enabled Not Requested Required *RequiredEnabled Enabled Optional perdevice entryOptional *RequiredEnabled Disabled Required Optional OptionalSecurity Mode Configuration On-node Device Table ConfigurationDataCalling Line Id PAP or CHAPSecurityCalling Line Id PAP Password orCHAP SecretDisabled Enabled Not Requested RequiredEnabled Enabled Optional perdevice entryRequiredEnabled Disabled Required Optional